Main

Made a few more corrections to the schematic and then started working on the actual PCB layout. The PCB will be approximately 2 inches by 3 inches.

Forgot to create PDF of lastest schematic.

Finished up schematic and started working on PCB. Then had to go back and fix schematic :( . Finally ran out of steam...

Finished up the first complete draft of the schematic.

Reworked a couple of the schematic symbols. Also redrew parts of the schematic after getting feedback from Andy.

Started working on the schematic. More work needed...

Finished creating footprints and schematic symbols for all components. Also adding the DD_Passives library for passive components from work. I'm not sure if the library includes footprints, but at least it has all the schematic symbols.

Continuing to create component footprints and schematic symbols. I also added the headers I'm going to use to the BOM.

Adding datasheet for 26 pin header that will be used to connect the daughtercard to the RPI.

Created footprint and schematic symbols for TMP512 and SAA1064T parts. Also created a schematic page for the daughtercard.