Good thing I did a final design check... it turns out that I had my pads misnumbered for both ICs. It took me a couple of hours to fix it but I think it's okay now.
Finished routing the board! Tomorrow Andy will tell me I did it all wrong...
Prerouting failsafe commit.
Made a few more corrections to the schematic and then started working on the actual PCB layout. The PCB will be approximately 2 inches by 3 inches.
Finished up schematic and started working on PCB. Then had to go back and fix schematic :( . Finally ran out of steam...
Finished up the first complete draft of the schematic.
Reworked a couple of the schematic symbols. Also redrew parts of the schematic after getting feedback from Andy.
Started working on the schematic. More work needed...
Finished creating footprints and schematic symbols for all components. Also adding the DD_Passives library for passive components from work. I'm not sure if the library includes footprints, but at least it has all the schematic symbols.
Continuing to create component footprints and schematic symbols. I also added the headers I'm going to use to the BOM.
Created footprint and schematic symbols for TMP512 and SAA1064T parts. Also created a schematic page for the daughtercard.