Fixing a few minor issues Andy noticed with my layout after I'd sent it out to fabrication (of course). These changes will be revision B of the board.
Did a final review and then created gerber files for fabrication.
Good thing I did a final design check... it turns out that I had my pads misnumbered for both ICs. It took me a couple of hours to fix it but I think it's okay now.
Made the reference designators a bit smaller and made some square pads to designate pin 1's.
Made a few more minor tweaks to the layout. I also moved the LED labels to the silkscreen layer (whoops).
Made a few tweaks to the layout including adding a board name and revision to the silk screen.
Made a couple of modifications based on Andy's feedback.
Finished routing the board! Tomorrow Andy will tell me I did it all wrong...
Prerouting failsafe commit.
Made a few more corrections to the schematic and then started working on the actual PCB layout. The PCB will be approximately 2 inches by 3 inches.
Finished up schematic and started working on PCB. Then had to go back and fix schematic :( . Finally ran out of steam...